Panasonic Quasar W-1301 Operating Instructions Manual page 18

This unit can be set to automatically power on in one of 2
modes (TV, Playback).
You can also combine the On-Timer with a one minute alarm
that gradually increases in volume.
Press PROG to display SET PROGRAM
screen.
1)Press AT to select
"ON TIMER."
2)Press I_ to display
ON TIMER screen.
3
1) Press AV to select
desired settings.
2) Press I_ to set the
ON-TIMER TIME or
ON-TIMER mode.
• Make sure a tape is
• ON-TIMERmode inserted if Playback
selection order mode is selected.
¢,cH02--cH03.--..cH_25-, I
4
Press AT to select
ALARM "ON" or
"OFF."
E_ Ready Check List
[] The clock is set to correct time.
<ModetW-2001 unit shown>
TIMER
CH ,kV ON TIMER
indicator
When "ON" is selected,
an alarm will gradually increase in volume for one
minute or until canceled by pressing any button
(including VOL + -).
To Make Corrections,
use AV and • 1_ to move back and correct.
Press PROG to set ON TIMER.
• "ON TIMER SET" is displayed.
• ON TIMER Indicator lights on the unit.
To Cancel ON-TIMER set,
Repeat steps 1 and 2. Then, press ADD/DLT to
clear the time in step 3. Now, press PROG to end.
"ON TIMER END" briefly appears on-screen.
18
• If no button on the remote or unit
(including a button used to turn off
the alarm) is pressed within 60
minutes after unit turns itself on,
it wilt turn itself back off.