Electrolux ESM48310SX User Manual page 22

22 www.electrolux.com
Problem and alarm code
The appliance does not
drain the water.
The display shows i20.
The anti-flood device is on.
The display shows i30.
The appliance stops and
starts more times during
operation.
The programme lasts too
long.
The displayed programme
duration is different than
the duration in the con‐
sumption values table.
The remaining time in the
display increases and
skips nearly to the end of
programme time.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
The appliance door opens
during the wash cycle.
Rattling/knocking sounds
from inside the appliance.
The appliance trips the cir‐
cuit-beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Possible cause and solution
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clog‐
ged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in
the user manual.
• It is normal. It provides optimal cleaning results and
energy savings.
• If the delayed start is set, cancel the delay setting or
wait for the end of the countdown.
• The pressure and the temperature of the water, the
variations of the mains supply, the options, the quan‐
tity of dishes and the degree of soil can change the
programme duration.
• This is not a defect. The appliance is working cor‐
rectly.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• Parts of the tableware are protruding from the bas‐
kets.
• The AirDry function is activated. You can deactivate
the function. Refer to "Settings".
• The tableware is not properly arranged in the bas‐
kets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneous‐
ly all the appliances in use. Check the socket amper‐
age and the capacity of the meter or turn off one of
the appliances in use.
• Internal electrical fault of the appliance. Contact an
Authorised Service Centre.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.