Table of Contents
Advertisement
HOW TO USE THE REMOTE
TO CONTROL
YOUR
TV
t
G
MENU, ENTER, CURSOR buttons
All the on-screen display features can be set or adjusted by using these buttons.
The "MENU" button will start or exit the on-screen display.
The "CURSOR" buttons will highlight functions or adjust different features.
The "ENTER" button will set features to your preference.
1_
SELECTOR
buttons
CHANNEL
"CHANNEL SELECTOR" buttons are used to set the time, for channel memory, etc.
Enter two or three numbers
to select channels.
Enter a "0" first for channels
1 to 9. For channels
100 and
higher, press the "1" button, wait until another dash appears next to the channel display on your TV, then enter
the remaining two numbers using the number buttons.
Channel selection may also be performed
by pressing channel up (A) or down (Y).
i
NOTE:
The TV may not receive some channels if you are not in the correct AIR/CABLE mode.
(See. page 25)
®
AVX button
The AVX (Auxiliary Video) button will select between the antenna signal and the two sets of video input jacks each
time the button is pressed.
If the Picture-in-Picture
(PIP) is on, the AVX will select between the two sets of video
input jacks. (See page 18)
_
".
I
Avx
©
I
VIDEO
2
16
Advertisement
Table of Contents
