Reviewing Time And Day Stamp; Setting Your Outgoing Message (Ogm) - Uniden DXAI685 User Manual

Press the flash/function key again.
6.
Note: A beep indicates the new time is programmed, and
the new Time and Day Stamp is announced from the
Base speaker. You are then prompted for a PIN code.
7. Enter the two-digit number you want to use as your PIN code.
8. Press flash/function again.
A beep indicates the new PIN number is programmed.
9. For example, to set the time to Tuesday at 3:20 PM, and
your PIN code to 00, press caller id , then press
flash/function , followed by these keys.

Reviewing Time and Day Stamp

6
1.
Press .
The speaker beeps, and the Time and Day Stamp is
announced.

Setting Your Outgoing Message (OGM)

When you receive a call, the Answering System answers and automatically plays either a preset message or
your personal Outgoing Message.
Preset Messages
The DXAI685 has two messages programmed in its memory. If the REC TIME/ANN/4/1 switch is in either the
four or one position, the first preset message below plays. Incoming messages are limited to four or one minute
respectively. If the switch is set in the left position, (i.e., the "Announce Only" position) the second message
below plays, and no incoming messages are recorded.
Hello. No one is available to take your call. Please leave your message after the tone.
Hello. No one is available to
Note: If the REC TIME/ANN/4/1 switch is in the "Announce Only" position, the Message Counter LED
displays an A when the system is in Standby.
t
ake your call.
43
flash/function
flash/function