Page 4
Introduction DANGER If you smell gas: Shut gas off to the appliance. Extinguish any open flame. If odour continues, keep away from the appliance and immediately call your fire department. WARNING Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.
Page 5
This instruction manual contains important information necessary for the proper assembly and safe use of the appliance. Read and follow all warnings and instructions before assembling and using the appliance. Follow all warnings and instructions when using the appliance. Keep this manual for future reference.
Contents GENERAL ADVICE PARTIAL ENCLOSURES PRODUCT OVERVIEW DATA PLATE 1 OPERATION & INSTALLATION SAFETY CONSIDERATIONS FIRE CARBON MONOXIDE 2 SETUP & ACCESSORIES ADJUSTING THE STONES MOVING THE OVEN OVEN PLACEMENT FLUE ASSEMBLY LPG BOTTLE SETUP DIGITAL TEMPERATURE DISPLAY SET UP DIGITAL TEMPERATURE DISPLAY TROUBLESHOOTING E1 ERROR CODE...
Page 7
TROUBLESHOOTING GAS BURNER DISCONNECTING GAS ANTICLOCKWISE REGULATOR 4 GENERAL MAINTENANCE MAINTENANCE CLEANING THE VENTURI CLEANING THE OVEN INTERNAL EXTERNAL REPLACING THE PROBE 5 PRODUCT WARRANTY WARRANTY...
Do not use the appliance indoors. It is within Dome S1. only suitable for use outdoors. Use heat-resistant gloves when operating For replacement parts go to Gozney. the oven. com. Do not insert items into Dome S1 that are bigger than the dimensions of the...
PARTIAL ENCLOSURES This appliance shall only be used in an Warning: Do not use the Dome S1 in above ground open-air situation with enclosed or on small balconies. natural ventilation, without stagnant areas where gas leakage and products of combustions are rapidly dispersed by wind and natural convection.
Product Overview - What's in the Box Oven Dock Spanner & Screwdriver Eye Bolts & Chain (use with the stand only) Gas Control Dial Gas Hose & Regulator Flue Top Flue Cap Flue Pipe...
Page 11
Flue Outlet Ø127mm Gas Inlet Stone Adjustment Tool Burner Guard Thermometer...
SAFETY CONSIDERATIONS This appliance must be installed on a secure level base prior to use. Do not cover oven mouth when there is an active flame, this will cause WARNING: This appliance will become damage to the oven. very hot, do not move it during operation.
CARBON MONOXIDE Carbon Monoxide is a highly poisonous gas which can be produced when the device isn’t receiving enough ventilation. We therefore recommend using gas fuels in a well ventilated area away from direct wind and to never cover the oven mouth when there is an open flame present.
Page 18
This section details the set up of the oven and the accessories included with your Dome S1.
Adjusting The Stones Before using Dome S1 it is important that the four blue stone retention wedges and other packaging inside of the oven are removed. The removable stone design of the Dome S1 means that they are not fixed inside the oven and as such can shift backwards during transport.
Moving the Oven The lifting straps located on the bottom of the oven are only suitable for single use. Please remove them once the oven is located to its final location and use hand holds below. Do not move Dome S1 whilst in operation or when it is still hot.
730mm OVEN PLACEMENT When deciding where to place Dome S1 ensure the area is large enough to accommodate the oven with 5cm around 628mm the base of the dock for air intake. 634mm 462mm 201mm WARNING When placing your oven it is important Always keep the area around the oven to maintain proper clearances from clear of any combustible materials,...
Page 23
We recommend the height of the floor to be around the level of the bottom of the users elbow (usually around 120cm from the ground) Ensure the surface the oven is being placed on is completely level, stable and capable of easily holding the weight of the oven - 60kg.
The flue is designed to have a rain guard which has a 5mm gap from the Dome S1. FLUE ASSEMBLY The rain cap prevents moisture from getting into the oven and should only be used when the oven is cooled and not in use.
WARNING It is important for the safe usage of Dome S1 that the gas bottle is secured to the oven as specified in the instructions below. LPG BOTTLE SETUP Remove F003 and replace with the eye bolt and chain that is in the box with the gas regulator.
SET UP After installing the batteries hold the power button down until the display turns on. Find the sensors jack by removing the plastic cap and plug it into the rear of the display, the screen will then show SECONDS the temperature from within the oven.
Digital Temperature Display Troubleshooting OVEN T OVEN T °F °F PROBE T ll PROBE T ll E1 ERROR CODE E3 ERROR CODE If the thermometer is displaying an If the thermometer is displaying an error code E1. This is caused by either: error code E3.
With its adjustable vents you’ll be able to control the temperature in the oven. For more details visit the Gozney website. www.gozney.com. WARNING Never use the door when the gas burner is lit.
Dome S1 Mantle makes moving food in or out of the oven simple. Easily bolting onto the oven, the Mantle is made from ceramic coated, food grade aluminum alloy for extra heat and scratch resistance. For more details visit the Gozney website. www.gozney.com.
Overview of gas firing This is an overview of the process for CONNECTING TO GAS igniting the oven. Check that the gas you are using is Ignition Instructions specified on the data plate page. 1) Remove all packaging from inside the oven mouth, including the blue stone The gas cylinder used must have a safety retention wedges.
If there is excessive Some foods produce flammable fats abrasion or wear it must be replaced and juices. Therefore the Dome S1 with a Gozney approved hose assembly oven should be attended at all times before use. whilst being used. Damage caused by fat and grease fires is not covered by warranty.
Page 36
Keep the cylinder outdoors in its upright position. Do not connect multiple gas cylinders to Dome S1 or store a spare within the same vicinity. A regulator which complies with AS 4627 or equivalent must fit between the gas canister and the oven. Do not position the gas canister under the oven.
INSTALLING THE IGNITER BATTERY Before using the gas burner for the first time you’ll need to install an AAA battery into the ignition module. To do this open the front hatch, the module will be inside and to the left. The module is held in place by a magnet, detach the module and pull it to the front hatch before unscrewing the cap and placing the...
CONNECTING THE GAS HOSE To attach the quick connection gas hose to your Dome S1 pull the collar back on the connector and place the hose onto the gas inlet. When you release the collar it should return to its original position freely.
CLOCKWISE REGULATOR Ensure the gas bottle is turned off. Align the regulator and the gas bottle threads and carefully begin to tighten ensuring the threads aren’t crossed. Continue to tighten until a tight fit has been made. This connection must be tested for leaks before using the oven.
Testing For Leaks If there is a leak at the hose to oven WARNING connection, re-tighten the fitting with a spanner and check for leaks by You should always check for gas applying a soap-and-water solution to leaks every time you disconnect and the highlighted areas with a brush.
Ignition Remove the door and the stone retention wedges before lighting the oven. Do not use the door with gas burner. To light the gas burner press the control knob in and turn the knob 90˚ until you hear a clicking sound and the burner ignites. The flame should be yellow in colour and roll along the top of the oven.
First Firing On your first firing we highly recommend to put the burner on a medium to low flame for 30 minutes to help cure the oven before moving to a high flame. Minutes Approx On subsequent firings after curing, you can bring the oven up to the desired temperature from ignition.
5 minutes and retry ignititing it. If the problem persists still review the cleaning and maintenance instructions to remove debris in the burner. If the problem persists after trying the following solutions please contact Gozney for further support.
Disconnecting Gas Minutes ANTICLOCKWISE REGULATOR After cooking, be sure to turn off the gas from the gas canister first before turning of the Dome S1. This will allow any gas left in the burner or pipe to be used up safely. Three minutes after turning the gas off it will be safe to remove the regulator and turn the control dial back to the off position.
Maintenance CLEANING THE VENTURI If your burner’s flame is overly yellow or making more noise than usual you may have debris blocking the venturi. When the oven is turned off, disconnected from the gas and cool, remove the rear right hand side panel using the torx screwdriver located in the front hatch of the dock.
Cleaning The Oven INTERNAL The best way to clean the inside of the Dome S1 is to burn off any food debris or soot that is left behind. When the oven is over 343˚C it will start self cleaning and any burnt on food will burn off after a period of four hours.
EXTERNAL For the exterior of the oven use a non caustic bleach free cleaning spray on the dirty areas. Clean the area with warm soapy water and a sponge or non abrasive dish cloth and then wipe clean with paper towels. Avoid spraying directly onto the thermometer or control dial.
Replacing The Probe OVEN T °F PROBE T ll Only when the oven is cold, remove the thermometer and unplug the cable. Unscrew the probe from inside the oven and pull the old probe out the mouth of the oven.
Page 52
Push the new probe's wires into the hole and feed them through until they are visible from inside the area where the thermometer is normally housed. Hand tighten the probe in place, avoid using a spanner as you may damage the probe. BEWARE: Don’t over tighten probe.
2001 Australia Contact Email Address: enquiries@gozney.com Contact Number: +61 (27) 2541582 Your Gozney product comes with a 1 year If you give us notice in writing during warranty as standard. the applicable warranty period within a reasonable amount of time following...
Page 57
We shall have no liability to you (whether the Products are found to breach the For our full warranty terms, please visit applicable warranty or not) for the cost of our website: https://au.gozney.com/ removing Products returned to us under pages/warranty the above conditions or for re-installing after they have been returned.
Need help?
Do you have a question about the S1 Dome and is the answer not in the manual?
Questions and answers