Changing The Digital Security Code; Installing The Beltclip; Optional Headset Installation - Uniden DCT748-4 Owner's Manual

Changing the Digital Security Code

Installing the Beltclip

Optional Headset Installation

[ 1 5 ] G E T T I N G S T A R T E D
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. Perform the "System Reset" options ("De-register the Handset" and "Replacing the Base
Setting") for all the handsets you have (see page 25).
2. Re-register each handset by following the steps on page 14.
To attach the beltclip
Insert the beltclip into the holes on each side of the
handset. Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from the
holes.
Your phone may be used with an optional headset. To use this
feature, insert the headset plug into the headset jack. Your
phone is ready for hands-free conversations. (Headset may be
purchased by calling the Uniden Parts Department or visiting
the web site. See page 69.)
w w w . u n i d e n . c o m