Husqvarna K 540i Operator's Manual page 20

•
• Make the final separating cut from the top of the
pipe pulling backwards, without involving the upper
quadrant of the blade. Adjust the blade guard to full
forward position for maximum protection.
WARNING:
supported, it should not pinch the blade
when separated in section 5. However
be alert if the blade is pinched during the
final separation. If the blade is pinched
in the lower section, the product may pull
forward away from the operator, rather
then resulting in a rotating kickback.
To prevent a kickback
WARNING:
there is a risk of kickback. Take care when
using your power cutter and make sure that
the blade is never pinched in the kickback
zone.
WARNING:
the blade in an existing cut.
WARNING:
work piece cannot move during a cutting
operation.
WARNING:
working technique can eliminate kickback
and its dangers.
20
4
5
If the pipe is properly
Avoid situations where
Be careful when you put
Make sure that the
Only you and proper
• Always support the work of piece so that the cut can
keep open when cutting through. When the cut is
open there is no kickback. If the cut is closed and
pinches the blade, there is a risk of kickback.
X-Halt
The X-Halt function is an electronic brake system that is
engaged if a kickback occurs. The function can not fully
prevent personal injury from a kickback, but it decreases
the risk. A safe working technique is necessary to
prevent kickbacks and to decrease the risk of injuries.
The X-Halt function is always on when the product is
on. If the function is engaged, the control panel shows
the X-Halt waning symbol until the product becomes
Troubleshooting on page 29 . For more
cool. Refer to
Troubleshooting on page 29 .
information, refer to
To do before you use the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 26 .
3. Make sure that only approved persons are in the
work area.
4. Make sure that you are in a safe and stable position
during operation.
5. Make sure that the water connector is connected
to a water supply. Refer to
water on page 24 .
6. Do a check of the rear handle (A) to make sure that
it is not damaged.
C
B
A
7. Do a check of the power trigger lockout (B) to make
sure that it operates correctly and that it is not
damaged.
8. Do a check of the control panel (C) to make sure that
it operates correctly.
9. Make sure that all parts and guards are correctly
attached and not damaged or missing.
Maintenance
To connect the coolant
1960 - 002 - 25.08.2023