Table of Contents
Advertisement
ttl
g the video channel
When a TV is connected with the 75 ohm coaxial cable only.
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR's channel selector, the TV must be set to
channel 3 or 4 (video channel).
Press and hold 3 or 4 on the remote for 3
seconds
in standby
mode.
The video channel will
C'_b
OR _'b
start to flash for 3
_
seconds in the display
window,
\
/
/
\
Press POWER to turn on the DVDNCR.
3
Press VCR DVD selector to select the VCR mode.
VCR
DVD
The VCR indicator on the
O
front panel will light,
_d;3
Turn ON the TV and set to CH 3 or 4 to corre-
spond with the channel selected in step t.
Press TV/VCR to select the VCR position.
TVNCR
The VCR indicator will
O
appear in the display
window.
Select any channel to receive a TV station in your area,
The channel
number will appear on the screen for
about 4 seconds.
•
For a push*button
TV tuner
If CH 3 or 4 corresponding
to the video channel cannot
be tuned on your TV, proceed as follows: set the VCR
3/4 channel selector and the TV to CH 3 or 4, play
back a prerecorded tape and tune the TV to receive a
sharp color picture from the video cassette recorder.
Refer to your TV owner's manual for details.
Notes:
• If the unit does not operate properly, or No key operation
(by the unit and/or the remote control):
Static electricity,
eta., may affect the player's operation.
Disconnect
the AC
power cord once, then connect it again.
• Dudng the DVD playback
if you change the operating mode
from DVD to VCR, the DVD will continue to play back the disc
and stop after about 5 minutes.
122
Advertisement
Table of Contents
