Advertisement
Connection
Caution
Reset Button
* This unit is designed for negative ground
When the installation and connections are over, be sure to press the reset button with a ball-point pen etc. The
12 V DC operation only.
reset button is located on the left of the connector on the unit side when the front panel is detached.
* Before making connections, disconnect the ground terminal of the car battery to avoid short circuits.
« Connect the yellow and red power input leads only after al] other leads have been connected.
¢ Be sure to connect the red power input lead to the positive 12 V power terminal which is energized when
ees
the ignition key is in the accessory position.
[Jf
|
* Run all ground wires to a common ground point.
CJ
Reset button
Connection Example
* For connecting an MD changer, refer to the "Installation/Connections" manual supplied with the MD changer.
Front speakers
Power amplifier
Lessceeccecccecoee: weesecce sa
Chim
RCA pin cord (RC-63 (1 m), RC-64 (2 m) or RC-65 (5 m)) (not supplied)
Rear speakers
Power amplifier
REAR LINE OUT/
AB
AB
FRONT LINE OUT/
LINE IN
Mcedic
ecco
c cole
tec
ess
N
'
'
'
a
a
'
,
7
'
a
A"
When connecting digital pre-amplifier
4 4
4 4
+
4
After connecting the Rotary Commander,
.
Digital pre-amplifier
install the plug holder @ to secure the
XDP-USOD
Rotary Commander plug.
Lis lel
rom
RCA pin cord (supplied to CD changer)
BUS CONTROL IN
CD/MD* changer
BUS cable (shielded type) (supplied to CD changer)
Rotary commander (supplied)
o
+
to a metal point of the car <qums 9
mmm
to the +12 V power terminal which is energized at ail times
o
,
to the +12 V power terminal which is energized in the accessory
position of the ignition key
White striped
Front speakers
TEL MUTE
mum
to the interface cable of a car telephone
ANT REM
=)
map
to 3 power antenna relay contro! box
Max. supply current 0.1 A
Green striped
Rear speakers
AMP REM
Blue/white strii
ped
=]
sm
to a remote control lead of the power amplifier
Max. supply current 0.3 A
Notes on the contro! leads
Notes on speaker connection
© The power antenna control lead (blue) supplies +12 V DC when you turn om the tuner or when you activate the ATA
© Before comnecting the speakers, turn the unit off.
(Automatic Tuner Activation) Function.
© Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Otherwise, the speakers may be
* A power antenna without relay box cannot be used with this unit.
damaged.
© Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the righ! speaker with
Memory hold connection
those
of the left speaker.
When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key
© Do nat attempt to connect the speakers in parallel.
is turned off.
© Do not connect any actine speakers (with built-in amplifiers) to the speaker terminals of the wnit. Doing so may damage the
actine speakers. Therefore, be sure to comnect passive speakers to these terminals,
Advertisement
