Brother RJ-3150 Manual page 115

RJ-3150
2. Feed Key Function
Select the operation that is performed when the
If [Program Settings] is selected, click the [File] button and select the command file.
Available settings: [Feed], [Program Settings]
3. Printer Information Report
Select which sections are printed when printing the printer setup information.
Available settings: [All], [Usage Log], [Printer Settings], [Printer Transfer Data]
4. Beeper
Select whether the printer beeps when an operation panel button is pressed.
Available settings: [On], [Off]
5. Serialize Mode
Select whether or not to serialise from the last number printed.
Available settings: [Cont From Last], [From Starting#]
6. Save Printer Print Log
Select whether or not to save the printer's print log. If [Disable] is selected, [Tools] - [Save Print Log in File] cannot be performed.
Available settings: [Enable], [Disable]
7. Print Data after Printing
Select whether or not print data is erased automatically after it is printed.
Available settings: [Erase All Print Data], [Keep Print Data]
Sensor Adjustment Tab
If RD Rolls are being used, it is unnecessary to adjust the sensors.
1. Disable these settings
When this check box is selected,
The settings in a tab where
[Export] command is executed.
To apply the settings to the printer or save or export them, be sure to clear the check box.
2. Media Sensor (Transmissive/Gap) (RJ-3150 only)
If RJ-3050 was selected for [Printer], this item is unavailable. The following transmissive/gap sensor parameters can be adjusted.
[Detection Sensitivity]
Adjust the precision of the sensor that detects the gaps (spacing) for die-cut labels
Available settings: -2–+2
[Luminescence Adjustment]
Adjust the amount of light emitted by the transmissive/gap sensor.
Available settings: -2–+2
3. Media Sensor (Reflective/Bar)
The following reflective/black mark sensor parameters can be adjusted.
[Mark Detection Sensitivity]
Adjust the precision of the sensor that detects the black marks.
Available settings: -2–+2
[Luminescence Adjustment]
Adjust the amount of light emitted by the reflective/black mark sensor.
Available settings: -2–+2
4. Media Sensor (Peeler) (RJ-3150 only)
If RJ-3050 was selected for [Printer], this item is unavailable. Specify the settings when the label peeler is used.
Adjust the precision of the sensor that detects whether the label has been peeled.
Available settings: -2–+2
Display Settings (1) Tab (RJ-3150 only)
This appears only if RJ-3150 is selected for [Printer].
(Feed) button is pressed.
appears in the tab, and the settings can no longer be specified or changed.
appears will not be applied to the printer even if [Apply] is clicked. In addition, the settings in the tab will not be saved or exported when the [Save in Command File] or
109 / 168
Go to Index
Go to Index