Advertisement
CONTROLS
CONNECTIONS
Stereo headphone socket HEADPHONES
For stereo headphones with 3.5 mm plug. In-
serting the plug will disconnect the loudspeak-
ers.
e
Check if the mains voltage as shown on the
type plate corresponds to your local mains
supply. If it does not, consult your dealer or
service organisation.
If the setis equipped with a VOLTAGE selec-
tor (Fig. 3), set this selector to the local mains
voltage.
000
+
— A
n
am
m
=>
=
—-——
—
— ——
A
RADIO
RADIO RECEPTION
e
Set the MODE selector to RADIO.
e
Adjust the sound with the VOLUME control
and the DYNAMIC BASS BOOST bass but-
ton.
Select the wave band using the BAND selec-
tor
(LW not on all versions).
For FM, pull out the telescopic aerial. To
improve FM-reception, incline and turn the
aerial. Reduce its length if the FM-signal is
too strong (too close to a transmitter).
For AM/MW and LW (Medium and Long
Wave), the set is provided with a built-in
aerial, so there is no need to use the tel-
escopic aerial. The aerial can be directed by
turning the whole set.
Tune to a radio station using the TUNING
knob.
When receiving a FM-stereo transmission a
disturbing noise may be heard due to a weak
FM-stereo signal. This can be suppressed by
setting the BAND selector to FM MONO.
You will then hear (and record) the FM pro-
gramme in mono.
The setis switched off if the MODE selector
is inthe TAPE OFF and the recorder buttons
are released.
-—
—
w
a
eee
——
—
Français
English
Espanol
Advertisement
