Drive Belt Removal/Lnstallation; Tire Pressure.16 - MTD Cub Cadet 1000 Series Operator's Manual

Maintenance (continued)
Drive Beit Removal/lnstallation
Set parking brake. Place drive controls
into neutral position before
removing/installing belts. Removing
tender will aid belt replacement/
adjustment (see "Fender Removal"
earlier in this section).
DRIVE BELT REMOVAL:
• Turn steering wheel to the LEFT.
Remove locknut (V, 6-20 & 6-21) at drag
link. Do not rotate ball joints.
• Loosen all belt guides and work belt
from belt path and off unit.
DRIVE BELT INSTALLATION:
GEAR DRIVE UNITS:
• Route belt around sheaves as shown in
Fig. 6-20.
• Adjust belt guides (A, Fig. 6-20) 1/16"
to 1/8" away from belt when the belt is in
the "engaged" or tensioned position.
Secure guides (A).
• Adjust belt guide (B) so it is pointing
straight to the left of the unit as shown in
Fig. 6-20. Secure guide (B).
NOTE:
Adjust Idler all the way to the rear in
slot.
• Adjust belt guide (C) so it is pointing
straight to the right of the unit as shown
in Fig. 6-20. Secure guide (C).
• Adjust belt guides (D) 1/16" to 1/8"
away from belt. Secure guides (D).
• Adjust belt guide (E) so it is pointing
50° back from straight left, as shown in
Fig. 6-20. Secure guide (E).
• Check that all idlers freely rotate after
assembly.
HYDROSTA TIC DRIVE UNITS:
• Route belt around sheaves as shown in
Fig. 6-21.
• Adjust belt guides (E) 1/16" to 1/8"
away from belt. Secure guides (E).
• Adjust belt guide (F) so it is pointing
straight to the right of the unit as shown
in Fig. 6-21. Secure guide (F).
• Adjust belt guides (G and H) 1/16" to
1/8" away from belt. Secure guides (G
and H).
• Adjust belt guide (Z) so it is pointing as
shown in Fig. 6-20,1/16" to 1/8" away
from belt. Secure guide (Z).
• Check that all idlers freely rotate after
assembly.
• Re-install fender if necessary.
Tire pressure
Always maintain proper tire pressure.
a. Front—12-14 PSI (82 - 96 kPa)
b. Rear—8-10 PSI (55 - 69 kPa)
NOTE: Inflate both front tires evenly.
Inflate both rear tires evenly. Unit will
not be level if this instruction is not
followed.
DO NOT OVER-INFLATE TIRES!
29