Table of Contents
Advertisement
Positioning and levelling
To keep vibration, noise and movement to a
minimum, it is essential that the machine is
absolutely level. Check this with a spirit
level when the machine is in its permanent
operating position. Any adjustments needed
can be made by using the open end of the
spanner supplied to raise or lower the two
adjustable feet at the front of the machine -
you merely screw them up or down (figure
3).
Some vibration is inevitable, especially if
mounted on a wooden floor, so make sure
there is a gap of at least 12mm (1/2")
between the machine and any wails,
furniture and so on.
Please ensure that when the appliance is
installed, it is easily accessible for the
engineer in the event of a breakdown.
Plumbing - cold water fill only
Your new Zanussi appliance has been
designed to be permanently plumbed in to
your home's water supply and drainage
system. However, if this is not possible, it
may be connected to suitable existing taps,
with the drain hose discharging into a sink.
The appliance a cold water inlet valve, with
a female 3/4" BSP thread connector. If this
connection size is not compatible with your
existing plumbing, a variety of connectors
are available from good hardware stores
and plumbers' merchants to suit most
domestic plumbing. Any alterations to your
existing plumbing must be carried out by a
competent person or qualified plumber.
Before connecting the hoses, be sure to fit
the mesh filters supplied as per figure 4.
Before connecting the hose, be sure to fit
the mesh filter supplied as per diagram.
8
Advertisement
Table of Contents
