Table of Contents
Advertisement
f) Remove the stop hook (4 figure 10) after
having removed the fixing screws from the
cabinet. Take out stud 5 (figure 10) pulling it
outwards from the bottom and then rotate it
by 90°. Refit the stop hook (4 figure 11) and
stud 5 (figure 11) on the opposite side.
Displace door closure (8 figure 10) bending
the two fastening wings in the direction of
the arrows on the closure itself. Turn the
closure upside down and push it till
fastening of the two wings.
g) Fasten the door on the opposite side by
means of hinge (6 figure 11) provided as an
attachment and using the two previously
removed screws. Check that the door is
aligned with the cabinet; to make this
operation easy, it is advisable to unloose the
screw (7 figure 11) provided next to the
hinge's fastening holes by two turns, then
tighten the screw again.
h) Fit into the seating provided on the door,
the flexible end of the door closing catch (1
figure 11).
Instructions for fitting decor panel on
door panel
The door of this washing machine is
provided with frames for fitting a decor panel
(kitchen laminates, etc.) to match the
washing machine's appearance with that of
the kitchen furniture.
The overall dimensions of the decor panel
should be as follows:
Width
588 mm
Height
588 mm
Max thickness
4 mm
To fit the decor panel, it is necessary to
release the decor frames by removing the
fastening screws.
Fit the decor panel and re-assemble all the
parts ensuring that the decor panel is
secured within the frames.
33
Advertisement
Table of Contents
