Frigidaire LGHK2336TF8 Use & Care Manual page 25

More about your Advanced
Water Filter
The PureSource Ultra II
ice and water filter system is
tested and certified to NSF/ANSI
Standards 42, 53 and 401 for the
reduction of claims specified on
the performance data sheet.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Test & certification results:
• Rated Capacity - 125 gallons/473 liters for
PureSource Ultra II
• Rated service flow - .65 gallons per minute
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
TM
ice and water filter
TM
CHANGING THE FILTER
To replace your PureSource Ultra II
water filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the
filter replacement.
1 Turn Off the ice maker power switch.
2 Remove the old filter by rotating it counter-
clockwise (to the left) 90 degrees to release it.
3 Slide the old filter cartridge straight out of
the housing and discard it.
4 Unpackage the new filter cartridge. Slide it
into the filter housing as far as it will go with
the grip end horizontal.
5 Push lightly inward on the filter while rotating
it clockwise (to the right). The filter will then
pull itself inward as it is rotated. Rotate the
filter 90 degrees until it stops and the grip
end is vertical. You may be able to feel a very
light click as the filter locks into place.
6 Press a drinking glass against the water
dispenser while checking for any leaks at
the filter housing. Any spurts and sputters
that occur as the system purges air out of
the dispenser system are normal.
7 Continue dispensing water for 3-4 minutes
or until 1.5 gallons of water has flowed
through the system. You will likely need to
empty and refill your glass several times.
8 Turn On the ice maker.
9 Press and hold the Water Filter reset
button on the control panel for three
seconds. When the display changes from
Red to Green, the status has been reset.
TM
25