Electrolux ESF 640 Installation And User Instructions Manual page 5

FITTING INTO KITCHEN UNITS
Before positioning the machine, you can set the feet
in approximately the right position at the front by
extending them downwards slightly.
Pass the hoses and mains cable through the hole at
the very back of the kitchen unit where appropriate.
Pull them in gradually, whilst guiding the machine
carefully in. Avoid lifting and pulling the control
panel. Check that the hoses have not kinked.
CONNECTING THE OUTLET HOSE
min 4 cm
=
+2 m max _/
max 100 cm
min 30 cm max
100 cm
- The hose must not be cut but may be extended to a
maximum of 4 m. If you do this, remember that the
minimum permissible internal diameter is 13 mm.
You may choose any of the following methods to discharge
the water from the machine:
1. Directly into the sink — by hanging the hooked end of the
hose over the edge of the sink. The top of the hook should
not be higher than 1,000 mm (40 in) above the floor. Please
note that if you choose this method, the sink should not be
used while the machine is operating as the water being
discharged is extremely hot.
2. Via a water-break to a fixed drain outlet. The water-break
is essential and should be positioned at least 500 mm (20 in)
above floor level to prevent water draining away from the
machine at times other than intended. The maximum
permissible height from the floor to the top of the drain hose
is 1,000 mm (40 in). The drain stand pipe should have a
minimum internal diameter of 38 mm (1.5 in). A trap.
should be provided between the standpipe and the drain to
prevent odours from escaping into the work area.
3. Into a Universal waste trap which replaces the sink
trap.