Husqvarna K 1270 II Operator's Manual page 25

9. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To start the product with a warm engine
WARNING:
blade can rotate freely. It starts to rotate
when the engine starts.
1. Push the decompression valve to decrease the
pressure in the cylinder. The decompression valve
goes back to its initial position when the product
starts.
24
Make sure that the cutting
2. Make sure that the STOP switch is in the left
position.
3. Pull the choke control fully to get the start throttle
position.
4. Push the choke control to disable the choke. The
start throttle stays in position.
5. Hold the front handle with your left hand.
6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
1631 - 001 - 04.05.2021