Husqvarna K 1270 II Operator's Manual page 24

2. Make sure that the STOP switch is in the left
position.
3. Pull the choke control fully to get the start throttle
position.
4. Push the air purge bulb 6 times until it is fully filled
with fuel.
5. Hold the front handle with your left hand.
6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
WARNING:
rope around your hand.
1631 - 001 - 04.05.2021
Do not wind the starter
7. Pull the starter rope slowly with your right hand until
you feel a resistance as the starter pawls engage.
Then pull continuously and quickly.
CAUTION:
rope fully and do not let go of the starter
rope handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the choke control when the engine starts. If the
choke is pulled out, the engine will stop after some
seconds. If the engine stops, pull the starter rope
handle again.
Do not pull the starter
23