Basic Operations; Audio Adjustments - Teac AG-360 Owner's Manual

OPERATIONS
Basic Operations
Audio Adjustments
1. Set the VOLUME control to "0". This is to protect
the speakers from a sudden high level signal.
2. Set the LOUDNESS button to the OFF position.
3. Set the BASS, TREBLE and BALANCE controls to
their center (click) positions.
4, Press the POWER button to turn on the power.
5. Select the required source by pressing one of the
function buttons.
The indicator lights steadily. To listen to a source
other than tape deck, set the TAPE MONITOR button
to the OFF position.
Note: When the TAPE MONITOR button is set to ON,
only the tape deck can be selected.
6. Start playing the source component. Gradually
increase the volume with the VOLUME control and
adjust the other controls as required.
7. When using headphones, connect the headphone
plug into the PHONES jack.
VOLUME
BALANCE
BASS/TREBLE LOUDNESS
VOLUME Control
This control is used to adjust the level of the signals
output to the speakers and headphones.
Tone (BASS and TREBLE) Controls
These are for boosting and attenuating low and high
frequencies. Response will be "flat" with the controls
in their center "click" positions.
BALANCE Control
This shifts the sound toward the left or right speaker.
LOUDNESS Button
This button compensates for the non-linear response
of the human ear at low volumes. Set this switch to
the OFF position when listening at normal levels.