Roland GR-700 Owner's Manual page 19

Cross Modulation
eSync: The frequency of the DCO-2 synchro-
nizes with that of the DCO-1. The fundamen- N
tal of the DCO-2 is decided by that of the tl
DCO-1. Therefore, you can generate a unique
sind waveform that is impossible to obtain by
Sync "Off" setting. Sync
Off. " « Metal nd 1
e Metal: By controlling the DCO-1 with the ( "| eae
de output signal from the DCO-2, ring modula-
tion style sound can be obtained.
e Off: Each DCO-1 and DCO-2 can have dif- Metal
ferent pitch and waveform. [NOTE 3] ; f
lt
Fine Tune The frequency (pitch) of the DCO-2 can be
Baer adjusted with this parameter.
my ae e Variable range... +15 cent er:
(438 ~ 446 Hz) Na
b g
Tune
Tune
This
adjusts the
frequency (pitch)
of the
DCO-2. N —1
e Variable range . . . Approx. +1200 cent co -e a
O
(1 octave)
l -l D
g
b
;
Lt!
LFO Depth LFO When the LFO output is modulating the DCO, ry ry
i this parameter is used to adjust the depth of = 1 ~
SAN the modulation. A ie
HO f=
IN f
0 10
ENV Depth Env When the ENV output is modulating the
; DCO, this parameter is used to adjust the =
DS depth of the modulation. § Es
a tie
fe XN
0 10
. . . . Mn
Polarity Switch This selects the polarity of the Envelope curve. =
Normally, / TU is used. In \7 mode, the LI
ADSR patterns will be all inverted, therefore, ae A
pitch alteration, too. The depth of the modu- td ern
MI lation is adjusted with the ENV Depth. I vr
y ra
Li
19