Table of Contents
Advertisement
SAFETY
Symbol in This Manual
A
This symbol indicates where applicable cautionary or
other information is to be found.
Power Source
This equipment
operates
from a power
source
that does
not apply more than 250 V rms between the supply con-
ductors or between either supply conductor and ground. A
protective ground connection by way of the grounding con-
ductor in the power cord is essential for safe operation.
Grounding the Product
This equipment is grounded through the grounding conduc-
tor of the power cord. To avoid electrical shock, plug the
power cord into a properly wired receptacle before connec-
ting to the equipment input or output terminals.
Use the Proper Power Cord
Use only the power cord and connector specified for your
product.
Use the Proper Fuse
To avoid fire hazard, use a fuse of the correct type.
Do not Operate in Explosive Atmospheres
To avoid explosion, do not operate this product in an ex-
plosive atmosphere.
Do not Remove Cover or Panel
To avoid personal injury, do not remove the cover or panel.
Refer servicing to qualified personnel.
Voltage Conversion
If the power source is not applied to your product, contact
your dealer. To avoid electrical shock, do not perform the
voltage conversion.
CONTENTS
SAFETY ssccccensavnerscvecsessanasenasacnas ciereiscveseeseeunts
2
FEATURES oie ci oecntenees biaiile seat yecnaccusersetesderite
3
SPECIFICATIONS ...........:.cceeeceeeeneeeeseeeneeseeeens
4
PREPARATION FOR USE.............:cssscesesseeeeneneees
6
CONTROLS AND INDICATORS ............0..e0seeeeeeee
8
8
OPERATION 3. ose sicsscsecceccsd
INITIAL STARTING PROCEDURE ...................::00::00 15
(1) NORMAL SWEEP DISPLAY OPERATION ................ 15
(2) MAGNIFIED SWEEP OPERATION................000csc00ee 18
(3) X-Y OPERATION ...........ccccceecceseeeseneeeeeeeseneeeeneaes 18
(4) VIDEO SIGNAL OBSERVATION ..............::eseceeeeeeee 18
PROBE COMPENSATION ..............:eseeecseesseeceseeeeees 19
Note:
This instruction manual is described for five models.
Refer to item applied to your product.
TRACE ROTATION COMPENSATION............:c.000000 19
DC VOLTAGE MEASUREMENTS. ...............:c0cceeseeees 19
BETWEEN TWO POINTS ON A WAVEFORM ........... 20
TIME MEASUREMENTS.................ccseceeenenevenereeeeees 21
FREQUENCY MEASUREMENTS .............:0c:eeeseeeeeees 21
PULSE WIDTH MEASUREMENTS ...............c0ceceeerees 22
TIME DIFFERENCE MEASUREMENTSG...................665 23
PHASE DIFFERENCE MEASUREMENTS. ................... 24
RELATIVE MEASUREMENTS. ................:::eeeeeeeeeeeees 24
APPLICATION OF X-Y OPERATION. ...........0.seseeeeeees 27
Advertisement
Table of Contents
