Cd Changer Basics (Only For Cq-2650Eu) - Panasonic CQ-2650EU Service Manual

CD Changer BasiCS continued (Only for Ca-2650EU)
Searching a Track
Press and hold "TRACK A \ * or "\/ TRACK" for mare than a half second
to activate fast forward or reverse through a track. Retease "TRACK A"
or "\V TRACK" to resume the normal CD play from that position.
Repeating a Track
Press REPEAT to repeat the current selection. "REPEAT indicator
fights. The current selection continues to repeat untit you press RE-
PEAT again.
eee
Random Selection
Press RANDOM. "RANDOM™ indicator lights. A random selection of
music is played from all available CDs. To turn it off, press RANDOM.
again.
Scanning Tracks
Press SCAN. The display blinks and the first 10 seconds of each track
'on the discs play in sequence,
To stop scanning and continue with the current track, press SCAN
again.
Changing the Display
Press CD-C to switch the display in sequence as follows.
Disc/Track Number
I
Track Play Time
Note: To change to the Radio mode, press BAND.
Alarm time Setting
Press and hold ALARM at all the time while setting the time.
& Keep holding ALARM for seconds and the "AdJ" blinks on the dis-
play, indicating the time setting mode is activated.
a
ALARM TE Adil
| ——
Coe C9
8° To set hours, press "\/ TUNE".
I =
wae MY Sa} —_
Si
To set minutes, press" TUNE".
ws Le
PM 8: 15)/—
>
Hold" \" or" \/" to change numbers rapidly.
'C: When you have set the time, release ALARM.
Resetting the Alarm time
When you want to resel the alarm time, repeat steps 'A' to 'C} above.
Alarm Operation
A: Alarm is switched to ON or OFF each time ALARM is pressed.
'8: When the Alarm is switched to ON, the alarm sound will activate at
the set alarm time.
Turning offthe Alarm Sound
The atarm sound will turn off automatically after 90 seconds. Other-
wise, press ALARM once,
CAUTION:
Be careful not to set the wrong alarm time because, othenvise, the alarm
may sound while driving.
¢ Ifthe alarm is set, be sure to check the set alarm time by pressing CLOCK.
it you operate the radio, etc. at the time set the alarm, the alarm sound
may be muted.
i
ik
|
oy he
CQ-2650EU/2500CEU
Clock Basics (The clock system is 12-hours )
Initial Time Setting
Press and hold CLOCK at all the time while setting the time.
A Keep holding CLOCK and the "AdJ" blinks on the display, indicating
the time setting mode is activated.
Le
—Adu)—
4
8 To set hours, press "\V TUNE".
Hold "A\" or "to change numbers rapidly.
© When you have set the time, releaso CLOCK,
Resetting the Time
When you want to reset the time, repeat steps 4: to .C above,
. .
Selecting the Clock Display
Press CLOCK to display alarm time.
Alter a few seconds, current time returns on display.
Note: The current time will display at all the time even the power of the
radio is turned off. In this case, it is normal.
Insiallation Guide
AX WARNING
This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not contain
warnings or cautions of potential dangers in attempting to install
this product.
Any attempt to install this product in a motor vehicle by anyone
other than qualified installer could cause damage to the electrical
system and could resuit in serious personal injury or death.
& Overview CO Installation Hardware
This equipment should be installed by a profession-
al. However, if you pian to install this unit yourself,
your first step is to decide where to install it. The in-
structions in these pages will guide you through the 5
remaining steps; (Please relerto "WARNING" state- Mounting Collar
ment above). -
Piain Washer (5 mm)
No. Item Diagram | Qty
3
© Identify and fabel the vehicle wires
e Connect the vehicle wires to the wires of the
power connector @® | Spring Washer (5 mm)
@ Install the unit in the dash
Check the operation of the unit eae 2
@ | Hex. Nut (5 mm) 9 2
® | Rear Support Strap 1
mm
5S
La
If you do encounter problems, please consult your
nearest professional installer,
CAUTION: This unit will operate with a 12 volt DC i © anes 25 mm)
negative ground auto battery system only. Do not
attempt to use it in any other system. Doing so . . | Toothed Lock Washer
could cause serious damage. ® {5 mm@)
Dismounting Pin
® | (U-shaped)
Before you begin installation, look for the following
items included in the packing with your unit,
@ Warranty Card ...... Fill this out promptly
@ PASC Servicenter Directory ...... Keep for future
reference in case the unit needs sarvicing
« Installation Hardware ...... Needed for in-dash
installation