Table of Contents
Advertisement
System Setting
6.
Before use, we recommend fully charging the Sensor battery.
Check if the Power Indicator in Sensor is off.
Find the proper installation location on vehicle, please refer to "Installation
Guide".
Power on the sensors to start to use:
I.
Please take out waterproof rubber.
II.
Use tool to press and hold sensor power button for more than 1
second, the Power Indicator will turn on "Red" for starting working.
III. After turn on Sensor, please put back waterproof rubber.
Note: The sensor will start detection in 30 seconds after it is powered on.
Display Mute：
I.
In normal mode：Press the Mute button for 1 second to activate
Display silent mode. The LED will flash and without "Beep".
II.
In silent mode：Press the Mute button for 1 second to inactivate
Display silent mode. The LED will flash and "Beep Beep".
Sensor power saving mode:
When the car is not moving, the Sensor enters a dormant state
automatically to save power
Battery：
I.
The power of the Sensor can be used continuously with sufficient
sunlight.
II.
The power of the Sensor can be used continuously more than 24
hours without sufficient sunlight.
III. When battery at low voltage state, the display will flash 2 times/Sec
until sensor battery re-charge completed; if the battery voltage run
out off power, the system will shuts down.
If sensor missing, display did not receive the paired sensor signal, the LED
at the corresponding position of the Display will flash 4 times/SEC
continuously, and the Buzzer will beep 4 times intermittently per second
for 60 seconds.
7.
Installation Guide
Before use, we recommend fully charging the Sensor battery.
● Sensor installation
The sensor can be installed both on vehicle with magnetic compatible
car body or not magnetic compatible car body.
8
Advertisement
Table of Contents
