Table of Contents
Advertisement
Sensor
Please make sure the Sensor is charged with type C or Solar power
charging before using it. Even the Sensor is not fully charged, the Sensor
still can work normally. Please remove cable when you find the Charging
Indicator from lighting status turning OFF.
To put back sensor's waterproof rubber when sensor charging is done.
Make sure that the vehicle installation location is compatible with
magnetic material. Sensor requires a flat area for better magnetic
mounting. If it is not compatible with magnetic material, please screw
metal bracket for magnetic mounting.
Display
Please make sure that the vehicle has USB socket for Display installation.
Plug USB Type C to display charging slot.
Find the proper display installation method on vehicle.
5.
Pairing of Sensor & Display
Pairing of Sensor & Display：
I.
Before pairing, please make sure Sensor is power OFF and Display is
power ON status. The distance between Sensor and Display needs to
be within 30cm to be paired.
II.
Adjust Sensor Position Switch to the expected installation position and
remark it on rear Sensor label.
III. Press Sensor power button 4 times within 2 seconds, the Display will
flash 2 times quickly with beep sound. It means the pairing process is
successful.
IV. Follow step II and III for pairing other Sensors, able to support 8
Sensors at the same time.
V.
The maximum for sensor pairing is 8pcs, if user want to pair the 9th
Sensor, the Display will flash 4 times with beep sound 4 times, which
means the pairing process is failed.
Note: If the Power Indicator in Sensor lights on, which will cause pairing
failure. Please power off the sensor and follow step I to pair sensor and
display again.
Clear Sensor Pairing:
Press Display Mute Button 3 times, after hearing the beep sound, then
press and hold the Display Mute button for 5 seconds within 3 seconds to
clear all pairing.
The Display will quick flash while the clear Sensor pairing process is
successfully.
6
Advertisement
Table of Contents
