Thank you for choosing VISION Solar Wireless Parking Assistant VAE-225. VISION Solar Wireless Parking Assistant is environmentally friendly and practical, easy to install. it uses ultrasonic sensors to help you judge how close you are to the obstacles. It provides a visual and audible alarm when close to large obstacles to aid the driver while parking.
Part List Display *1pcs Mute button Indicator Solar Powered Parking Sensor * 2pcs Solar panel Sensor Reflector Waterproof Rubber Power Indicator Charging Indicator Type C Charging Sensor Position Switch Power Button...
Page 4
Metal Plate for Sensor *2pcs Screws for Metal Plate *4pcs Display Bracket *1pcs Large Double-sided tape (Display/Display Bracket) *1pcs Small Double-sided tape for Display *1pcs USB/Type C cable *1pcs...
Features Easy to Install: Magnetic mount No drilling & No wiring Solar Powered: The Sensor is rechargeable through natural daylight. Provide reliable & self-sustained power by solar light panel, no replacing battery. III. Power Saving: The Sensor will be in standby mode while vehicle is stationary. Specifications ...
Sensor Please make sure the Sensor is charged with type C or Solar power charging before using it. Even the Sensor is not fully charged, the Sensor still can work normally. Please remove cable when you find the Charging Indicator from lighting status turning OFF.
Page 7
Sensor Position Switch Instruction : Note: 1 Display can be paired with 1 to 8 sensors.
System Setting Before use, we recommend fully charging the Sensor battery. Check if the Power Indicator in Sensor is off. Find the proper installation location on vehicle, please refer to “Installation Guide”. Power on the sensors to start to use: Please take out waterproof rubber.
Page 9
Minimum height from the ground Condition 2: Condition 1: For not magnetic compatible car Solar Powered Parking Sensor body, the metal plate needs to be uses magnets to be directly locked with screws on the car attached to the magnetic body first, and then the Solar compatible car body.
Page 10
Remark: If you need to install 2 sensors on the same side, the suggested minimum distance between sensors is 80cm. ● Display installation We provide 3 methods for display installation, user can find the proper location for display installation on vehicle dashboard or on windshiled : Option 1: Paste the small double-sided tape on the bottom of the Display and fix it on the dashboard, or any location for better driver viewing.
Display Display Bracket Large double-sided tape Detection & Alarm The detection alarm according to different distance. Display LED Detection Item Alarm Remark Range Indicator ≤50cm:Constant Beep The alarm will be ≤50cm:Flash 50cm ~ 100cm:Beep. Beep. off after 30 seconds 50cm ~ 200cm:On Sensor 200cm (shortly)
Trouble Shooting & Notice If you require mute function, please press Mute button on Display Under paired status, if the Display flash quickly with beep sound, it means the bad detection signal or the signal is interfered. Please adjust the display to a higher position and away from metal part. III.