Glass Shelf Installation; Initial Start-Up; Start-Up Troubleshooting - U-Line Origins 75BEV Installation Manual

4. Place the two hook-hinges (located on the rear bottom
side of the grille) onto the front lip of the unit base.
Swing the grille up into position, aligning the grille
screw hole on the grille to the grille screw hole on the
cabinet. See Figure 22.
Hook-Hinge
Figure 22
5. Insert the screw. Do not overtighten.
6. Reinstall control knob.

Glass Shelf Installation

(75R Refrigerator and 75BEV Beverage Centers Only)
1. Carefully remove the glass shelves from the packaging.
2. Slide the shelves onto lower sets of ribs, making sure
the decorative graphics are on the underside of the
shelves. While edge strips go toward the rear and silver
edge strips (75R Only) go toward the front. See
Figure 23.
Figure 23
www.U-LineService.com
75R, 75WC and 75BEV Models
.
Grille
Hook-Hinge
Unit Base
Front Lip
9 Start-Up for the First Time

Initial Start-Up

The unit is shipped with the control preset to a mid-point
setting between 4 and 5. Assure that setting was not
altered in shipment. No other adjustments should be
necessary at this time. For information about Adjusting
the Temperature Control, see the User Manual.

Start-Up Troubleshooting

Q:
Problem
Unit does not appear to turn on when plugged in.
A:
Solution
Make sure outlet has power (circuit breaker has not
tripped).
Q:
Problem
The light stays on when the door is closed.
A:
Solution
Make sure on/off switch is turned OFF. Check to see that
light switch actuator bracket is contacting the light switch
properly.
See the User Manual's Troubleshooting Guide for more
solutions.
12
IMPORTANT
02/2005