Advertisement
MAINTENANCE/INSPECTION PROCEDURE
5-2) Greasing
(1) Greasing guidelines
Apply grease, with a cleaning patch. Do not use exces-
sive grease. It may come into contact with the tape
transport or drive system. Wipe excessive grease and
clean with cleaning patch wetted in Isopropyl Alcohol.
NOTE:Greasing Points
1) Loading Path Inside & Top side
2) Base Assembly P2, P3 stopper
3) Shaft
4) L/D Motor Gear Wheel Part
2
1
7
Chassis (Top)
Gear Part
Gear Sector
Base Loading
Chassis (Left Side)
5) Arm Take-up Rubbing Sections
6)Reel S,T shaft(G381:Yellow)
7) Arm Assembly F/L Rotating
Sections
4
3
6
Gear Cam
Gear Drive
Guide Rail
Chassis (Right Side)
(2) Periodic greasing
Grease specified locations every 5,000 hours.
1) Loading Path Inside & Top side
2) Base Assembly P2,P3 stopper
3) Shaft
4) Shaft
5) Clutch Assembly D35 Shaft
3
4
5
7
4-21
6) Plate Slider Guide Sections
7) Plate Slider Guide Sections
8) Gear Assembly P2, P2 Rubbing
Sections
2
7
6
Slider Guide
5
Slider Guide
Chassis (Bottom)
Gear Rack F/L
Plate Slider
1
8
Advertisement
