BMW X1 Owner's Manual page 113

refer to page 97, while selector lever posi‐
tion R, D or M/S is engaged.
▷ If the driver's safety belt is unbuckled, the
driver's door is opened, and the brake pedal
is not pressed while the vehicle is stationary
and selector lever position D, M/S or R is en‐
gaged.
▷ After the ignition has been switched off while
selector lever position N is engaged.
Engaging selector lever
positions: with a latching
selector lever
General information
To prevent the vehicle from creeping after you
select a drive mode, maintain pressure on the
brake pedal until you are ready to start.
Functional requirements
The selector lever can only be taken out of se‐
lector lever position P if the ignition is on or the
engine is running.
Engaging selector lever position D,
N, R, or P
With the vehicle stationary, depress the brake
pedal before shifting out of selector lever posi‐
tion P or N; otherwise, the shift block will not be
deactivated and the shift command will not be
executed.
A selector lever lock prevents the following faulty
operation:
▷ Unintentional shifting into selector lever posi‐
tion P or R.
Online Edition for Part no. 01402631131 - X/19
Driving
▷ Unintentional shifting from selector lever po‐
sition P into another selector lever position.
1. To release the selector lever lock: with the
brake pedal depressed, press the button on
the front of the selector lever.
2. Move the selector lever into the desired posi‐
tion.
Engaging selector lever
positions: with a tap-operated
selector lever
General information
To prevent the vehicle from creeping after you
select a drive mode, maintain pressure on the
brake pedal until you are ready to start.
Functional requirements
Only when the brake pedal is depressed is it
possible to change from selector lever position P
to another selector lever position.
Depending on the transmission version, the en‐
gine may have to be running too.
The selection lever position P cannot be
changed until all technical requirements are met.
CONTROLS
113