Advertisement
1500ELE Assembly Instruction
Assembly
1. Remove the lift and all parts from the wooden crate.
2. Connect 110V power to the lift and press the hand operated magnetic remote to
raise the lift.
3. Raise the lift to a comfortable work height.
4. It is important to use a short thick extension cord. Using a long thin cord can
cause a significant amp-loss to the motor and destroy the motor.
5. The pump comes prefilled with 1.26 quarts of AW32 hydraulic fluid, so nothing
is required for the lift to be ready to operate.
Front Extension Assembly
1. The front extension slides over the main body of the lift.
2. It is recommended the front extension be used with the side extensions as the
tubes that hold the side extensions in place also hold the front extension in place.
Side Extension Assembly
1. There are two holes in the main body of the lift on each side.
2. Place one side extension support tube through each one of the holes in the lift.
3. There are two corresponding holes in each of the side extensions. Carefully slide
the side extension onto the two tubes protruding from the main body.
4. Perform the same task with each side extension.
5. In the hardware bag there are (4) pins with clips.
6. Install one pin in each hole in the end of the side extension tube.
7. Put one clip in each of the (4) pins to deter the pins from becoming dislodged.
Advertisement
