Speed Over Ground (Sog); Velocity Made Good (Vmg); Temperature; Maximum & Average Speed - Raytheon ST80 Multiview Operation & Setup

Hide thumbs Also See for ST80 Multiview:

Table of Contents

ST80 Multiview Operation and Setup Manual

Speed Over Ground (SOG)

• Speed over ground can be displayed in KTS, MPH or KMH.

• VMG is only displayed if your system is configured for use with

sailing vessels.

• VMG can be displayed in one of the following KTS, MPH or KMH.

• The sea temperature can be displayed in degrees C or F.

• The decimal place is lost if the temperature rises above 99.9.

Maximum & Average Speed

• The trip, log and maximum and average speed displays can be reset

by pressing and holding the speed key for 4 seconds. The display

flashes during this process.

Log & Trip

• The Masterview is capable of displaying up to 5 trips at any one

time. However, the Multiview will only repeat the first of these trips.

• The depth is displayed in the units currently available on SeaTalk

(FT, M or FA).

• Trend arrows replace the depth units (providing the trend option is

switched on) if the depth increases or decreases at a rate greater than

the value in User Setup.

Minimum & Maximum Depth

• The maximum and minimum depth displays can be reset by

pressing the depth key for 4 seconds. The display flashes during

this process.

• This display shows the depth transducer offset currently available on

SeaTalk.

• The offset can be either: waterline (positive offset), keel (negative

offset) or transducer (zero offset).

Table of Contents