OPERATION OF THE APPLIANCE ______________________
Replacement of Lamp
Disconnect the hood from the mains supply.
This appliance is equipped with 3 W halogen
lamps.
To replace the halogen lamps, press the lamp
downwards from the rear section of the lamp
holder to release the lamp. Then turn it counter-
clockwise by 1/4 tour and remove it.
Perform the above steps in reverse order to fit the
new lamps.
Max 3W
Fig. 1
C
You may procure lamps from
Authorised Service Agents.
You may use this appliance in the exhaust air
mode and the ventilated air mode.
Operation with Chimney Con-
nection
The suctioned air is cleaned by the grease filters
and is exhausted through a piping system (Fig. 2).
Fig. 2: Exhausting the air without a carbon filter
INDICATION!
The exhaust air does not have to
A
be transferred to an active fume or
exhaust air tube, nor to a chimney,
in order to ventilate the areas where
the heat sources are installed.
If you wish to transfer the exhaust air in an
■
inactive waste fume or gas exhaust tube, you
must get permission from an authorized chim-
ney sweep.
If the exhaust air is exhausted through the ex-
■
ternal wall, you must use a telescopic wall tray.
ENGLISH
9