Camera Rear - Aiwa ICD-820DAB Instruction Manual

Speakers
Unused speaker wires need be insulated with tape,
heat shrink, or crimp connectors. Never use wire
nuts.
If the speaker outputs are not used, turn OFF the
internal amp to reduce the possibility of noise
entering the signal chain.
Observe speaker polarity when making connections.
1
2
4 5
3
6
7
Camera/USB/MIC
Check out the connections you find on the previous graphic.

CAMERA REAR

Images may appear reversed
Do not use a feature of this product if it cannot be
operated safely and legally in your location.
Parking Brake
For Android Auto setup, the parking brake status wire
must be connected.
Review the connections of this product, to properly
integrate the parking brake wire to the vehicle. Video
and or photos cannot be viewed while driving. The
vehicle must be stationary and the
parking brake applied to enable viewing.
The parking brake input needs to be connected to the
parking brake wire.
Every vehicle has a different type of parking brake
connection; consult a certified professional installer.
Hands-free mic
Placement
Every vehicle will perform differently due to layout,
interior materials, etc.
We recommended placing the mic in the following
placement:
12
ICD-820DAB
8
9
10 11
13
12
1
Location
to plug in
Audio Pre-amp/AV IN/ Radio
Subwoofer Pre-amp is a non-fading mono output.
Always run signal wires away from power cables to
reduce the possibility of noise.
1.Microphone Input
2.Front Camera Input
3.Rear Camera Input
4.USB Play/ Charging
5.Apple CarPlay Android
Auto
6.USB2
A 7.USB1
2
3.Radio
2. Audio/video Inputs
1. Pre-Amp Audio Outputs
(From/rear speaker outputs
and two subwoofer outputs)
8.Wire Harness Connector
9.Fuse (15A)
10.Audio/Video Inputs
11.FM/AM Antenna Jack
12.Pre-Amp Audio
Outputs
13. DAB
Light green,
Parking
Brake Input
Location to plug in
4. AM/FM
Antenna
Jack
E