Screen(G2), Drive, White Balance, Sub Colour And Sub Brightness - Sony TRINITRON KV-M2170A Service Manual

3-3. SCREEN(G2), DRIVE, WHITE BALANCE,
SUB COLOUR and SUB BRIGHTNESS.
C board
RV701 SCREEN
Screen (G2) setting
1.
Oye Pa BS
Input a O IRE (Black Level) signal from the pattern
generator.
Enter into the Service Mode "Test""Test" and 38.
Adjust RV701 until the Down arrow is displayed.
Adjust RV701 until the Down arrow just disappears.
Press the TV Button on the Remote Commander to store
the data.
1.
N
Os Ri
Input a Video signal containing a small area of 100%
white on a black background.
Connect an oscilloscope to Pin of J701 (R OUT)
on the C Board.
Set the Picture to maximum using "Test""Test" and 01.
Enter into the Service mode (Adjust Menu).
Using the Blue and Green buttons select "RED HWB".
Using the Red and Yellow buttons on the Remote
Commander adjust until the oscilloscope waveform has
an amplitude of 85V.
85V
White Balance Adjustment
1.
we
Input an al] white pattern from the pattern generator.
Adjust the Colour and Brightness controls to the standard
level.
Enter into the Service Mode.
Adjust the Green HWB and Blue HWB so that the
White Balance becomes optimum.
—19—
KV-M217
Sub Colour Adjustment
Ne
eres
Input a PAL colour bar pattern from the pattern generator.
Connect an oscilloscope to Pin of J701 (B OUT)
on the C Board.
Enter into the Service Mode "Test""Test" and 22.
Using the Red and Yellow buttons on the Remote
Commander adjust until the oscilloscope waveform
becomes as follows :
B. OUT
Note : If the TV is able to receive PAL and SECAM
transmissions, repeat the above procedure using a Secam
colour bar signal.
Sub Brightness Adjustment
1. Input a Philips pattern from the pattern generator.
2. Enter into the Service Mode "Test""Test" and 23.
3. Using the Red and Yellow buttons on the Remote
Commander adjust until the 0 IRE of the grey scale and the
cut off are only slightly visible on the screen.
3-4. FOCUS
1. Receive a television broadcasting.
2. Normalize the picture setting.
3. Adjust the focus control on the flyback transformer to
become the focus in the centre area properly.
Bring only the centre area of the screen into focus, the
magenta-ring appears on the screen. In this case, adjust the
focus to optimize the screen uniformly.
Focus