Samsung WA25B8377 Series User Manual page 18

Installation
STEP 5 Power on
Plug the power cord into a wall socket featuring an AC 220-240 V / 50 Hz approved electrical outlet
protected by a fuse or circuit breaker. Then, press POWER to turn on the washing machine.
STEP 6 Running a test cycle
Run a test cycle as follows to check if your washing machine is properly installed.
1. Load about 6 pounds of laundry into the tub.
2. Press POWER to turn on your washing machine.
3. Turn the Cycle Selector to RINSE+SPIN.
4. Press and hold Hold to Start to start the test cycle.
5. The washing machine should not rock or vibrate excessively when water is supplied or when washing or
spinning, and should drain well during the spin cycle.
NOTE
• If water leaks while water is being supplied or drained, check the water connections. Refer to the
"Connect the water hose" section on page 14 for instructions.
• If the washing machine rocks and vibrates excessively, level your washing machine again. Refer to the
"Levelling your washing machine" section on page 13 for instructions.
STEP 7 Calibration Mode
Your Samsung washing machine detects the laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after the installation.
To run Calibration Mode, follow these steps:
1. Remove laundry or any contents in the machine.
2. Press and hold Water Level and Delay End simultaneously for at least 3 seconds when the power is
turned on.
3. Press and hold Hold to Start to activate Calibration Mode.
4. The pulsator rotates clockwise and anticlockwise approximately 1 minute.
5. When Calibration Mode is finished, "0" appears on the display, and the washing machine automatically
turns off. The washing machine is now ready for use.
18 English
Untitled-4 18 2023-09-27 12:10:25