Table of Contents
Advertisement
Master Volume
F6 – Master Volume
When you activate F6, the Master Volume will begin increasing. If you are at 0 (no
volume), the first time you turn on F6 it will take approximately 3 seconds to get to
100% volume. When you get to your desired volume level, turn F6 off.
The next time you toggle F6 on it will drive the Master Volume to 0. If you are at
100% it will take approximately 3 seconds to get to 0. When you arrive at your
desired level turn F6 off.
It works like a volume slider – the first time you enable F6 it goes up and stops at
100%. Toggle F6 off and then back on and it will go down to 0 and stop.
Forward/Reverse Signal
Just like a real engine, you can announce the direction of intended movement using
your DCC handheld and F9 and F10.
F9 – Forward Signal
Pressing F9 twice (toggling on then off) will sound the Forward Signal. This is two
whistle/horn blasts
F10 – Reverse Signal
Pressing F10 twice (toggling on then off) will sound the Reverse Signal. This is three
whistle/horn blasts
Grade Crossing Signal
Again, just like a real engine, you can trigger the Grade Crossing Signal on your
engine. This is two long, one short, one long whistle/horn blast.
F11 – Grade Crossing Signal
Pressing F11 twice (toggling on then off) will sound your Crossing Signal.
M.T.H. HO 4-8-8-4 Big Boy Steam Engine
18
Advertisement
Table of Contents
