HOW TO INITIALIZE THE TV/VCR COMBINATION
To put the program back at the factory-default,
initialize the TV/VCR Combination as the following
procedure.
1. Use the service remote control unit.
2. Turn the power on. (Use main power on the TV
unit.)
3. Press [WAKE-UP/SLEEP] button on the service
remote control unit to enter the Service mode.
(Refer to "How to Enter the Service mode" on
page 1-6-1.)
4. Press [VOL p] button on the service remote
control unit twice, and confirm that OSD indication
is "7F = FF." If needed, set it to become "7F = FF"
by pressing [CH o / p] buttons on the service
remote control unit.
5. Confirm that OSD indication on the four corners
on TV screen changes from on and off light
indication to red by pressing a [DISPLAY] button.
(It takes one or two seconds.)
6. Turn the power off by pressing main power button
on the TV unit, and unplug the AC cord from the
AC outlet.
1-7-1
T5517INT