Volkswagen Arteon 2021 Workshop Manual page 94

Arteon 2021 ➤, Arteon Shooting Brake 2021 ➤, Golf 2013 ➤, Golf 2017 ➤, Golf Var ...
High-voltage system - General information - Edition 02.2021
NOTICE
Risk of damage to paintwork structure caused by activator.
– Apply activator onto adhesive bead with precision and do
not spill.
– Apply activator to cut-back adhesive seam.
Preparations before sealing
– Open one-handed clamps -VAS 6900/4- and distribute
around high-voltage battery 1 -AX2-.
– Have bolts ready for top high-voltage battery shell.
– Have tools ready.
– Prepare adhesive cartridges of 2-pack window adhesive set
by removing metal base and pressing content inwards at
edge of adhesive cartridges then place down.
– If several cartridge sets are required, all of them must be
prepared in the same manner beforehand so as not to un‐
necessarily prolong the bonding process.
– Insert cartridges of 2-pack window adhesive set with con‐
necting adapter in double cartridge gun -VAS 5237-.
– Carefully actuate double cartridge gun -VAS 5237- until both
components (black and white) can be seen.
– Screw green mixer nozzle onto connector so that opening
points down vertically.
– Then draw an adhesive bead of max. 10 cm to ensure that
both components mix.
Bonding high-voltage battery 1 -AX2-
NOTICE
♦ Use disposal gloves during the bonding process.
♦ Have a suitable implement ready (e.g. scraper) to tidy up
the adhesive seam afterwards.
♦ To shorten the amount of time needed to apply the adhe‐
sive bead, it is advisable for 2 persons to apply the adhe‐
sive bead in parallel.
♦ The adhesive bead should not be applied too quickly as
otherwise it will be too thin and of an insufficient height.
– Apply adhesive bead -1- to bottom high-voltage battery shell,
observing the correct speed of application.
90
Rep. gr.93 - Electric drive systems