Acorn 80 Maintenance Service Manual page 49

2 Assemble the thrust washer to the power bogie
casting aligning with location pin. Ensure that the
friction face is facing the rail.
3 Position the hub to the casting in alignment with the
other rollers. Ensure the centre-pop mark on the hub
is positioned to the bottom.
4 Secure the hub to the casting by re-assembling the
retainer ensuring that the rollers are aligned
ACORN 80 Maintenance & Service Manual
Dismantling Components
FRICTION
FACE
LOCATION PIN
CENTRE MARK
THESE
ROLLERS MUST
BE ALIGNED
RE-ASSEMBLE
RETAINER AS
ABOVE
SECTION 7
49