Table of Contents
Advertisement
© National Instruments Corporation
vision, and motion devices. Since PXI devices use PXI backplane signals
for timing and synchronization, no cables are required.
Cables
In most applications, you can use the following cables:
•
SH37F-37M-x—37-pin female-to-male shielded I/O cable, UL Listed
derated to 30 Vrms, 42.4 V
•
R37F-37M-1—37-pin female-to-male ribbon I/O cable
SH37F-P-4—37-pin female-to-pigtails shielded I/O cable
•
Custom Cabling and Connectivity
Refer to the
Custom Cabling
for more information about custom cabling solutions.
Appendix A
, or 60 VDC
pk
section of Chapter 2,
A-7
Device-Specific Information
DAQ System
Overview,
NI 6238/6239 User Manual
Advertisement
Table of Contents
