Table of Contents
Advertisement
2.
Lift Motor Head. Turn screw slightly counterclockwise (left) to raise Flat Beater
clockwise (right) to lower Flat Beater
surface of Bowl. If you overadjust the screw, the locking lever may not lock into place.
NOTE: When properly adjusted, the Flat Beater
Bowl. If the Flat Beater
coating may wear off the beater or wires on whip may wear.
*Also available as an optional accessory.
12
. Make adjustment with Flat Beater
*
or the Wire Whip
*
*
*
will not strike on the bottom or side of the
is so close that it strikes the bottom of the Bowl,
or
*
, so it just clears
*
Advertisement
Table of Contents
