Kenwood TH-235A Instruction Manual page 50

6
7
PTT switch cover
Cover for
, ae MIC/ SP/ DG IN jacks
¢ Completely mate the edge connector on the TSU-8 with
the connector in the transceiver.
e Thecomponent side of the TSU-8 must face the rear of
the transceiver.
Component side
Fold the plastic cover of the TSU-8 toward the
transceiver rear cover.
8 Replace the inner assembly onto the front cover, then
replace the cover for the MIC/ SP/ DC IN jacks.
e First mate the MIC and SP jacks of the inner assembly
with the corresponding holes of the front cover.
e |fthe PTT switch cover came off in step 5, replace the
cover so that the notch on the cover faces as shown.
9 Replace the inner partition.
* First mate the tabs of the inner partition with the tab holes
of the front cover.
« The charging electrodes must be correctly projected out of
the holes of the inner partition.
10 Replace the rear cover (3 screws).
11 Re-install the top rubber cover, the antenna, VOL
control, and Tuning control.
12 Re-install the battery pack or battery case.