Table of Contents
Advertisement
Model 606A
SPECIFICATIONS
(CONT'D.)
MODULATION
BANDWIDTH:
EXTERNAL MODULATION:
ENVELOPE
DISTORTION:
MODULATION
METER ACCURACY:
INCIDENTAL FM:
SPURIOUS FM:
SPURIOUS AM:
FREQUENCY
DRIFT:
POWER:
SIZE:
WEIGHT:
ACCESSORIES AVAILABLE:
DC to 20 kc maximum,
depends
on carrier frequency, fo;
and
percent
modulation
as
shown
in the following table:
30% Mod.
70%
Mod.
Square Wave Mod.
Max.Mod.Frequency "906 a. 0.021,
0.0031,
(Skemax)
0 to 100% sinusoidal modulation de to 20 kc.
4.5 volts peak
produces
100% modulation at modulating frequencies from
de to 20 kc,
Input impedance is approximately 600 ohms.
May also be modulated by square waves and other complex
signals,
At output levels of 1 voltor less; less than 1% at 30% modu-
lation using internal 400/1000 cps source, less than 3% from
0 to 70% modulation.
Within +5% from 0 to 90%.
At
Il volt or
less
output
and 30% amplitude modulation:
0.0025% or 100 cps, whichever is greater.
Less
than
0,0001%
or
+20
cps
whichever
is greater.
Hum
and
noise
sidebands
are
70 db below carrier down to
thermal level of 50 ohm output system.
Less
than
0.005%
or
5 cps
whichever
is greater, for a
10 minute period after warm-up.
115/230 volts 410%, 50 to 1000 cps, 135 watts.
Cabinet Mount:
20-1/2 in. wide, 12-1/2 in. high,
14-3/4 in. deep.
19 in. wide,
10-1/2
in. high, 13-1/2 in.
deep behind panel.
Rack
Mount:
Cabinet Mount:
Net 46 lbs., shipping 66 lbs.
Rack Mount:
Net 43 lbs., shipping 65 lbs.
606A-34A
Output Termination.
Three positions:
50 ohms,
for use into high impedance;
5ohms (10:1 voltage division);
IRE Standard
Dummy
Antenna
(driven from
10:1 divider).
lii
Advertisement
Table of Contents
