Advertisement
1. Right
hydraulic-component
cover
2. Flange-head capscrew
(3/8 x 1 inch)
5.
Align the slot in the hydraulic-component cover
with the full-threaded bolt (3/8 x 2 inches).
6.
Assemble the hydraulic-component cover to the
machine, and thread the flange-head capscrew
and full-threaded bolt into the threaded inserts.
7.
Torque the flange-head capscrew and
full-threaded bolt to 37 to 45 N∙m (27 to 33 ft-lb).
8.
Repeat steps
4
through
hydraulic-component cover at the other side of
the machine.
Preparing to Install the Chain
Guards
1.
Assemble 2 clip nut (10 mm) onto the guard
mount
(Figure
9).
Figure 8
3. Left hydraulic-component
cover
4. Full-threaded bolt (3/8 x 2
inches)
7
for the other
g349610
1. Clip nuts (10 mm)
2.
Repeat step
3.
At the bottom of the machine, assemble a
flange-head capscrew (5/16 x 1 inch) through
hole in the hydro mount bracket
5
Figure 9
2. Guard mount
1
at the other side of the machine.
(Figure
g349720
10).
Advertisement
