Page 1
Form No. 3438-786 Rev A Shredder Bar Kit Model No. 134-4194—Serial No. 400000000 and Up Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine.
Page 2
Installing the Kit Parts needed for this procedure: Shredder bar g317987 Carriage bolt (10 X 25 mm) Flange locknut (10 mm) Procedure At the bottom of the deck, align the holes in the shredder bar to the holes in the deck (Figure g317982 Figure 2...
Page 3
g318183 Figure 5 1. Carriage bolts and flange 3. Carriage bolt locknuts 2. Flange locknut Assemble the other carriage bolts (10 X 25 mm) and flange locknuts (10 mm) to the holes in the fine cut baffle and deck. Torque the flange locknuts to 47 to 57 N∙m (34 to 42 ft-lb).