Advertisement
INSTALLATION
Unpacking
Before installing the machine up, the packing must be
removed as follows.
You are advised to keep al
case the machine is to be
tthe packaging for re-use in
transported again.
Lay the machine carefully
on its back making sure
that the hoses, mains lead
and plug are not squashed.
Unscrew and remove the
two bolts.
Remove the inner block
by pulling out the red ring.
Set the machine upright,
then using a spanner re-
move the two nuts at the
back of the machine.
Remove the two plastic
spacers by pulling out the
red rings.
Plug the holes with the
black plastic plugs sup-
plied with the instruction
booklet.
Open the lid and take the
polystyrene block away.
Positioning
Your new Zanussi washing machine has been designed
to be permanently plumbed in to your home's water
supply and drainage system. However, if this is not
possible, it may be connected to a suitable existing
tap, with the drain hose discharging into a sink.
The appliance has one inlet hose, with female 4" BSP
thread connector. If this connection is not compatible
with the plumbing of the existing installation, a variety
of connectors are available from good hardware stores
and plumbers merchants to suit most domestic plumbing.
Any alterations to your existing plumbing must be
carried out by a competent person, or qualified plumber.
Water inlet
Before connecting the
hose be sure to fit the mesh
filter supplied as per dia-
gram.
Installation should comply with local water authority
and building regulations' requirements.
If you cannot make the water connection direct from
the rising mains, you may be able to operate the appli-
ance from your cold water storage system.
There should be a minimum distance of 5.02m (16 Vet)
between the appliance's inlet and the bottom of the
tank.
Advertisement
