Skil PWRCORE 20 PR0600B-00 Owner's Manual page 24

e. Lift the kickback guard. Place the guide bar on the mounting surface by sliding the guide-
bar slot over the screw (Fig. 17e).
f. Replace the side cover and lightly tighten the side-cover knob by turning it clockwise, but
do not fully tighten it (Fig. 17f).
To extend the guide bar life, invert the bar occasionally.
NOTICE
CAUTION
g. Lift the tip of the guide bar up to check for sag (Fig. 17g). Hold the tip of the guide bar
up and tighten the side-cover knob securely and fold the tab. The chain is automatically
tensioned now. The chain is correctly tensioned when there is no sag on the underside of
the guide bar and the chain is snug, but it can be turned by hand without binding (Fig. 17h).
If chain is too tight, it will not rotate. Loosen the side-cover knob slightly. Lift the
NOTICE
tip of the guide bar up and retighten the side-cover knob securely. Assure that the
chain will rotate without binding.
Fig. 17e
Screw
Tension Pin
Fig. 17g
24
The saw chain must be properly tensioned before using.
Rotation Direction Arrow
Cutter Pattern
Sprocket
Fig. 17f
Fig. 17h