Advertisement
To Install
n
1. Installation should be in accordance with acceptable plumb-
ing practices. Flush all piping thoroughly before installation.
Installation and field adjustment are the responsibility of the
installer.
2. Locate suitable place for the tempering valve. Valve should
be accessible for service and adjustment and as close to
the point-of-use as possible.
3. Connect hot and cold supplies to valve and outlet of tem-
pering valve to fixture (s) using 1/2" or 3/8" compression
connections.
4. Turn on hot and cold water supplies. If any leaks are
observed, tighten connections as necessary to stop leaks
before proceeding.
5. Turn on fixture and allow water to flow for 2 minutes.
Measure water temperature at the outlet. If water is not at
desired temperature, adjust as necessary (see temperature
adjustment section). Maximum outlet temperature of 105°F
(41°C) is recommended.
Temperature Adjustment
1. Loosen locknut.
2. Turn on fixture and run water for at least two minutes to allow
supply temperature to stabilize.
3. Turn temperature stem counter-clockwise for hotter or
clockwise for colder outlet temperature.
4. Tighten locknut to prevent accidental or unauthorized
temperature adjustment.
5. Re-check outlet temperature.
Repair Kit
n
Motor Repair Kit: ................................................................ 480 270
Warranty
n
The Seller warrants that the equipment manufactured by it and covered by this order or contract is free from defects in material and workmanship and, without charge, equipment found to be defec-
tive in material or workmanship will be repaired, or at Seller's option replaced F.O.B. original point of shipment, if written notice of failure is received by Seller within one (1) year after date of shipment
(unless specifically noted elsewhere), provided said equipment has been properly installed, operated in accordance with the Seller's instructions, and provided such defects are not due to abuse or
decomposition by chemical or galvanic action. THIS EXPRESS WARRANTY IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES, GUARANTEES, OR REPRESENTATIONS, EXPRESS OF IMPLIED.
THERE ARE NO IMPLIED WARRANTIES OF MERCHANTABILITY OR OF FITNESS FOR A PARTICULAR PURPOSE. The Seller assumes no responsibility for repairs made on the Seller's equipment unless
done by the Seller's authorized personnel, or by written authority from the Seller. The Seller makes no guarantee with respect to material not manufactured by it.
IS-P-G480_E480 2351
n
EDP#6512252
Typical Installation
WARNING: This product contains chemicals known
to the State of California to cause cancer and birth
defects or other reproductive harm.
For more information: www.watts.com/prop65
USA: T: (888) 432-8932 • PowersControls.com
Canada: T: (888) 208-8927 • PowersControls.ca
Latin America: T: (52) 55-4122-0138 • PowersControls.com
© 2023 Powers
Advertisement
