Advertisement
KNOWING YOUR
Use your hazard lights, warning triangle,
VEHICLE
etc to show that your vehicle is
stationary. Passengers should get out of the
vehicle, particularly if it is heavily loaded, and
SAFETY
wait for the wheel to be changed away from the
traffic. If you are on a slope or uneven surface,
place wedges or other suitable objects under
the wheels to secure the vehicle. Have the
STARTING AND
wheel repaired and refitted as soon as possible.
DRIVING
Do not apply grease to the bolt threads before
fitting: they could come unscrewed.
WARNING LIGHTS
AND MESSAGES
Use the jack only to replace wheels on
the vehicle with which it is supplied
IN AN
or on other vehicles of the same model. Never
EMERGENCY
use the jack for other purposes, such as lifting
other models. Never use the jack to carry out
repairs under the vehicle. Incorrect positioning
SERVICING AND
of the jack may cause the lifted vehicle to
CARE
fall. Do not use the jack for loads higher than
the one shown on its label.
TECHNICAL DATA
INDEX
148
WARNING
WARNING
WARNING
Incorrect hub cap assembly may cause it
to come off when the vehicle is moving.
Never tamper with the inflation valve. Never
introduce tools of any kind between rim and
tyre. Check tyre and space-saver wheel
pressures regularly, referring to the values
shown in the "Technical data" chapter.
Please note that:
the jack weight is 1.76 kg;
the jack requires no adjustment;
the jack cannot be repaired and in the event of a
fault it must be replaced by another genuine one;
no tool other than its cranking device may be
fitted on the jack.
To change a wheel, proceed as follows:
stop the vehicle in a position that is not dangerous
for oncoming traffic where you can change the
wheel safely. The ground must be flat and
sufficiently compact;
switch off the engine and pull the handbrake;
engage first gear or reverse;
wear the reflective safety jacket (compulsory by
law in certain countries) before getting out of
the vehicle;
Advertisement
