Maintenance, Cleaning And Care - Proxxon PRX1059 Manual

Connect the vacuum cleaner (Fig. 4)
We recommend to always work with the dust
extraction. Our "Compact Workshop Vacuum
Cleaner CW-matic" with automatic cut-off is
ideal for this use.
1. Put connection adapter 1 on the connecting
piece of the device
2. Put on the rubber connecting piece 2 and
insert the vacuum cleaner hose. The fl exible
rubber material makes it possible to use
different diameters.
Changing the grinding belt (Fig. 5)
1. Press the tightening roller 1 axially and remove
grinding belt from driving roller 2.
2. Place the new grinding belt fi rst over the
tightening roller 1. Then press the tightening
roller towards the back and place the belt over
the driving roller 2.
Adjusting the grinding roller (Fig. 6)
The grinding belt must run centrally on the tigh-
tening roller. If not, it needs to be readjusted.
Caution, risk of injury!
The device must run with this setting. Please
proceed with the greatest possible caution for
the belt running adjustment!
The running belt represents a potential hazard
and can cause injuries if the device is handled
carelessly!
1. Switch on the device by turning the button 1
and setting the small belt speed.
2. Turn the adjusting screw 2 to the left or right
until the belt runs centrally on the tightening
roller 1.
Adjusting the grinding head (Fig. 7)
1. Press in locking button 1 whilst adjusting
the grinding head 2 to the desired angle.
2. Release the locking button. The grinding
head engages.
Working with the device (Fig. 8)
1. Activate the device with the rotational speed
regulating knob (1, Fig. 1) and set the right
- 12 -
speed for the work.
2. The grinding surface 2 is particularly suited
for machining fl at surfaces.
3. Grinding surface 1 is best used to grind curves.
4. Face side 3 is suited for work on tight openings
and recesses.
Not excessive contact pressure is what achie-
ves a high grinding performance but rather the
correct and uniform speed.

5 Maintenance, cleaning and care

Caution:
Remove the battery from device before any
assembly, adjustment, maintenance measure
or repair!
Every device is dirtied by dust when working
with wood. Cleaning is therefore essential. To
ensure a long service life, however, the machi-
ne should be cleaned with a soft cloth or brush
after each use.
Mild soap or other suitable cleaning agent may
be used in this context. Solvents or cleaning
agents containing alcohol (e.g. petrol, cleaning
alcohols etc.) should be avoided, since these
can attack plastic casings.
Always keep the apertures required for cooling
the motor free of dust and dirt.
Service note
Please note: The mains power input for the
charger may only be replaced by our Proxxon
Service Department or a qualifi ed specialist!
6 Accessories
For more detailed information on accessories,
please request our device catalogue from the
address specifi ed on the last page in the war-
ranty information.
Note:
Note: