Important Note To Installer - Samsung WF45H6300AG/A2-01 User Manual

IMPORTANT NOTE TO INSTALLER
Please read the following instructions carefully before installing the washer.
These instructions should be retained for future reference.
We recommend you hire a professional to install this washer.
Installation flow chart
Selectinga _ Removingthe shipping _ Connecting thewater
location bolts (*Drumonly) andthe drain
T
i i i ii i ii i
Please Adjusting the _ poweringyour washing
check again levellingfeet machine
before
steps.
[
Yes
DOes
yourwasher
haveexcess vibration
or noise?
Running a Calibration mode
(RefertOthe following _ Finish the
installation
No description)
STEP 1
Removing the Shipping Bolts
Before using your washer, you must remove all shipping bolts from the
back of the unit.
1, Loosen all the bolts with the supplied wrench.
2, Slide the bolt and spacer up and remove the bolt with the spacer
through the hole in the rear wall of your washer. Repeat for each
bolt.
3, Cover the holes with the supplied Bolt Hole Covers (See page 13).
4, Keep the shipping bolts and spacers for future use.
STEP 2
Selecting a Location
_ Before you install your washer, make sure the location:
Has a hard, level surface.
Is away from direct sunlight.
Has adequate ventilation.
Will not freeze (tempuratures are never below 32 °F or 0 °C).
Is away from heat sources such as oil or gas.
Has enough room for the power cord.
Doesn't have any carpeting that will obstruct ventilation openings.
Englsh 15
\\TF45H6 03385A ENindd 15 2014 ] 10 9:26:31